Tiny Touch Plate

  • Sale
  • Regular price $8.49

Tiny Touch Plate V1.

The Touch Plate is 0.5mm thick stainless steel. It has nice flex to it but it can be bent if you would prefer a little angle to it.

The Kit Comes with;

1- Stainless Steel 0.5mm thick touch plate

1- Wire, 1.5M (60"), 22AWG with a female dupont plug on one end already.

1- Alligator clamp, easily handle 1/8" to 1/4" endmills

1- Fancy Spade connector.

1-1/8 in x 1/4 in Neodymium Cylinder N42 (ND004) Magnet

 This is a DIY bag of parts because I know you all like to personalize things. Cut and crimp the wire to a length suitable for your build.


The Refill Comes with;

1- Stainless Steel 0.5mm thick touch plate



The alligator clip should be connected to the Zmin negative, and the plate to the S (signal) pin. All V1 Firmware is and has been ready to use this type of plate.

Start or tool change Gcode can use a

G28 Z

G92 Z0.5

G0 Z5 F480


This homes Z

This tells the board it is now at 0.5mm above the Z plane

This moves the Z axis up 5mm to let you remove the clamp and probe.


Further details can be found on the Milling Basics page.